Install configuration check

Moderator: NorbertKrupa

Post Reply
Posts: 1
Joined: Wed Jan 08, 2014 6:05 pm

Install configuration check

Post by margyman » Wed Jan 08, 2014 6:25 pm

Is it possible to run the preinstall system config check without installing the rpm first? If so how?

User avatar
Site Admin
Site Admin
Posts: 1825
Joined: Sat Jan 21, 2012 4:58 am

Re: Install configuration check

Post by JimKnicely » Wed Jan 08, 2014 7:18 pm

Hmm. Without installing the rpm? The only way I can think is to manually check each of the checks the installer will perform. You can review the "Before You Install HP Vertica" section of the installation guide to get an idea of the checks performed... And look over the "Operating System Configuration Task Overview" section in the Vertica 7 Installation Guide. It has a lot of detail and describes some of the errors and warnings the installer may generate.

The install guide can be found here: ... _Guide.pdf
Jim Knicely


Note: I work for Vertica. My views, opinions, and thoughts expressed here do not represent those of my employer.

Post Reply

Return to “Vertica Premium Edition”